RF Relay Sequencer
DESCRIPTION:
Event sequencer for proper RX to TX transmition, and the return to RX mode. This sequencer based on modern STM32F0 CPU. Internal CPU clocking guarantees high precision and long-term stability, no capacitors, no external timing network, everything is digital. Sequencer has four high current MOSFET switches on output, they switching in 3 step (stage) with delay. Delay time can be selected by onboard jumper from two values - 15ms or 45ms.Three of MOSFET output port is "OPEN DRAIN" and "ground" active - OUT1, OUT2 and OUT3. Fourth MOSFET output port has external DC +12-30 input line (IN+) that switched ON (to OUT+ line) in TX mode and has same timing diagram as OUT3.
Output ports not protected, just bare DRAINS, so - be carefull, don't forget to use diodes in parallel with relay coils.
Sequencer can be switched to TX or RX mode by external footswitch only (active state - ground).
TECHNICAL SPECIFICATION:
* Board size is 70 x 45 mm
* Output ports: 4 ports, 50v/3a max
* Input ports: Footswitch (active state - ground)
* Delay time: 15 ms or 45 ms, onboard jumper selectable
* DC input: 5-12VDC, >0.1A
You will get soldered and tested PCB with uploaded firmware.
